Binding machines typically used for companies and schools to create a small booklet. These machines to connect to a large stack of paper, the formation of brochures, publications and reports. The most binding machine is a spiral or comb binding machine. Although these machines use a slightly different technology, they gave similar results. Shackles of work look more sophisticated and professional than binding. The binding machine is slightly different brand, so the manual will provide additional guidelines.
A spiral mold will die cutting machine. Push the handle up to lock in place the spiral.
2 Set the appropriate measurement of the vane sliding up or down. The machine should have 11-inch and 8-1/2 inch and 5-1/2 inch and 4-1/4 inch gap.
Three test machines. Insert an appropriate size of paper, then press the pedal. Remove the paper and confirmed that the hole in the right position. The hole should be on the left edge of paper, and should be covered by the paper from top to bottom.
4 Insert the file you wish to bind. Do not too many machines. binding consumable most machines have a maximum capacity of between 10-30. Symbol on the machine, you should tell your maximum capacity. Press the pedal, so that a punch.
5 papers by hole slide binding.
An adjustment necessary to punch mold and profits. Slide into the machine guide the appropriate location.
2 Insert the machine required pages.
3 Pull the handle red page.
4 Pouch laminator inserted into the machine in close connection with the comb.
Posterior：The main purpose of manual creasing